Dry the roof carefully ensuring it is 'squeaky ' clean with no traces of wax or grease . THIS IS THE MOST IMPORTANT STEP. YOUR VGs MAY FALL OFF IF THE ROOF IS NOT COMPLETELY CLEAN. .
Do not remove backing yet
“VG
FUELSAVERS”
Installation Instructions
| Wash the roof of your vehicle. Clean the
roof thoroughly 100 mm forward of the rear window using the supplied
wipes.
Dry the roof carefully ensuring it is 'squeaky ' clean with no traces of wax or grease . THIS IS THE MOST IMPORTANT STEP. YOUR VGs MAY FALL OFF IF THE ROOF IS NOT COMPLETELY CLEAN. . |
|
| Find the middle of the rear window and mark with arrow as supplied | |
| Align the template tape, above the back window
edge on the roof with a 'FUELSAVER' word centred on the arrow.
|
|
| Stick the template to the roof and check the alignment- if necessary re- position the template | |
| Place VG's with narrow end forward in front of
each 'FUELSAVER' word on the template tape.
Do not remove backing yet
|
|
| CAUTION: Hatchback vehicles need to be checked for clearance to ensure VG's will not hit bodywork when hatch is opened. | |
| If you don't have clearance move the template tape towards rear of vehicle until clearance exists | |
| Once satisfied VG's are in place and have clearance, peel off backing paper and press each VG firmly in place for 20 seconds | |
| Remove template tape from roof of vehicle and dispose of thoughtfully. | |
| You are ready to go - HAPPY FUELSAVING! | |